Materials and tools needed
Materials- Wooden plate
- Piece of wood (about 5cm*5cm*25cm)
- Slowly rotating motor. I used a 12V motor with a reduction system from an old copier. It is imporant that it has a low speed (about 100 RPM) and a high torque
- lots of screws
- Large wood-drill, it's important that it has a deep cut to transport the food
- small piece of tube, to connect the drill to the motor (both the shaft of the motor and the drill have to fit in the tube)
- clamps to fasten the tube around the shaft and drill
Tools
- Drill
- Saw
- Screwdriver
- Sandpaper
posted by Miyagi @ 9:39 a.m.
0 Comments:
Een reactie posten
<< Home